LinkBack URL
About LinkBacksLet me see if i have this right. On the reinstall of the firing pin on a !st Gen p3at the screw just rides back and forth on the flat spot.After you turn the screw out half a turn. CORRECT?
Let me see if i have this right. On the reinstall of the firing pin on a !st Gen p3at the screw just rides back and forth on the flat spot.After you turn the screw out half a turn. CORRECT?
Last edited by tdtree; 02-12-2012 at 06:32 PM.
Yep! The 1st generation P-3AT firing pin is nearly identical to the P-11 design. Here's a link that may be helpful. GoldenLoki.com
Thanks, already had it installed just wanted to be sure it was right. I used the GoldenLoki site to Buff & Fluff earlier.
Cool! I didn't notice if GoldenLoki recommended using any LockTite. If you didn't apply any during the initial installation, putting a tiny dab of the green wicking variety on the screw opening so it will travel down the hole by osmosis always worked well for me.
Thank`s, used my blue loctite when I did it.
Test
You'll Shoot Your Eye Out, Kid
Posting Permissions
Reply With Quote